Hi guys! For KISS FC fans, i made this little thingie... Specs: - 0.96 inch while OLED screen with protection shield - 5 way navigation...
I had small issues with power from irc vtx... on very sharp stops (RC26 and newer seems to be more agressive) i was loosing OSD image. I put a...
What do u mean "pads on the bottom"??? Do you mean rx-tx pads on the ESCs??? thats easy... desolder motor and pull escs up... You even dont need...
Don't hide it too deep ;) i sent few days ago new version of firmware for OSD with bug fixes and without garbage when logger is being used ;)
hoi. mijne bo is te koop. net veeeeel extras. zie in te koop sectie van het forum. extra armen. pdb. etc.
nice. still on ztws. ;)
start with defaults. its flyable. rates sre very personal thing. i do rcrate-1, r/p rate-0.6 and taw rate 0.4
Flash it with betaflight and forget about looptimes, forget about pidc0.... With this (f)cpu power use pidc1 or pidc2.... Pidc2 (luxfloat) flies...
pidc0 should be deleted (which is actually done in betaflight already ;)... default pids will get you in the air, but you will miss a smile ;)))
Thats ok then. ;) Never used profiles myself, never had urge to ;)
Just move to latest clean/beta flight, and go pidc1 or pidc2... One remark... You show us profile 3... Are u sure u selecting it before u...
Wrong post
yes. on rcgroups. thats the one.
well. if u are interested in flying, betaflught is a hot cookie right now. ;) thanks to Boris. :)
keep all defaults. if motors get worm - lower dtermcuthz. luxfloat is nice on betaflight. default pids are quite high for all my quads. i go...
taer-anis :) easy to remember :)
mode 1 or 2 should not affect channels. its just phisical location of gimbals :) glad it works.
channel mapping should be taer1234 may be?
Glad it helped. ;)
Never used servos... There are some parameters for servo smoothing... set servo_lowpass_freq = xx set servo_lowpass_enable = xx of course, has...
Scheid namen met een komma.
